Wiring The Monitor - Clarion VM700B Mode D'emploi Et Manuel D'installation

Wiring the Monitor

Precautions
• Disconnect the negative (-) battery terminal before making any wiring connections.
• Be particularly careful where you route cables. Keep the cable away from source of
heat, such as the engine, exhaust system, and etc. Heat can damage cables.
• If the fuse should blow, make sure all connections are correct and no wires are
damaged before replacing the fuse. Always use fuses that are the same amperage
value as the original. When replacing a fuse, never let the battery side touch any metal
part or any other wire.
Procedure
1. Find a place in the vehicle for the video source(s).
. Connect the  mini DINs connectors of  meters cable to monitor's DIN connectors.
. Run the  meter cable thru the inside car seat back to the bottom. Remain about 0
centimeters inside the car seat.
4. Create passage holes for the power and video cables.
When drilling through metal or plastic, use grommets to protect the cables from sharp
edges that could penetrate the insulation and cause a short circuit and device failure.
5. Connect the ground lead (black) securely to a clean metal plate on the vehicle.
Use sand paper to remove any paint from the surface where you attach the ground
terminal.
6. Reconnect the negative (-) battery terminal.
7. This monitor is recommended to be installed by professional installer.
3 meters
(~10 feet)
VM700B Manual 08509 R.indd 15
VM700B
BLACK
FILTER
BOX
FUSE
YELLOW
RED
AUDIO R1
WHITE
AUDIO L1
YELLOW
VIDEO 1
RED
AUDIO R2
WHITE
AUDIO L2
YELLOW
VIDEO 2
ACC
GROUND
+12V
15
VM700B
8/8/009 9:58:8 AM