Installing The Mounting Tray In The Headrest; Removing The Monitor From The Tray - Clarion VM700B Mode D'emploi Et Manuel D'installation

Installing the Mounting Tray in the Headrest

1. Remove the headrest from the car seat.
. Position mounting tray in a center of the headrest.
. Mark the headrest along the outline of the mounting tray.
4. Cut the opening and the foam in the headrest along the marked line with utility knife.
5. Insert the tray and check for fitting.
Make sure the mounting tray is flush mount on the headrest. Remove more foam from
the headrest, if required.
6. Secure the mounting tray to the headrest frame by using 4 Phillips screws included in
a package.
7. Route the power cable from the back side of the monitor through the side opening of
the mounting tray.
8. Insert the monitor in the tray. Press the edges of the monitor, not on screen, until it
snaps in the tray.
NEVER press on the surface of the screen! Gently press on the
edges of the monitor case. If you find that you cannot insert the
monitor without excessive force, you may need to check your wire
harness position for interference with the insertion process. Your
may also need make the opening slightly larger.

Removing the Monitor from the Tray

1. To remove the monitor from the tray, insert the metal plate (included in a package)
between the monitor case and the side of the tray to release the spring clips.
14
VM700B
VM700B Manual 08509 R.indd 14
CAUTION
8/8/009 9:58:8 AM