Publicité
Les langues disponibles
Les langues disponibles
V 1.45
Symptom
Intermittent spray
Pattern arched
Uneven pattern
The center of the pattern is too narrow
Poor atomization / Spray concentrated
into the centre
Little or no paint output
For any technical questions, please call 1-800-665-8685
TROUBLESHOOTING
Problem
•
Presence of air in the paint circuit.
•
Material residue in the holes obstructs
the passage of material.
•
The nozzle is dirty or malfunctioning.
•
The atomization cap is dirty or
damaged.
•
Material builds up on the outside of
fluid nozzle tip, or center hole, or
partially clogged nozzle orifice.
•
Loose fluid nozzle.
•
Atomization of air pressure is too high
•
Material too thin
•
The flow of paint is greater than the
pressure and quality of air supplied.
•
Fluid passage is clogged with dirt.
•
Air holes in the cover are blocked.
•
Fluid needle stroke is small.
8
Solution
•
Tighten the nozzle using the wrench
provided.
•
Make sure that the tank is empty.
•
Check that the connecting hole is not
obstructed.
•
Tighten the gland screw or replace the
gasket if worn.
•
Submerge the head in solvent.
•
Clean and open all closed holes with a
jet or compressed air or a toothpick.
•
Do not use pointed metal objects, or
you may deform the hole of the head
part.
•
Clean the head and nozzle.
•
Make sure that the centering between
the two is precise.
•
Check the tip of the pin is not ruined.
•
Replace the nozzle and the head.
•
Reduce the quantity of air and increase
the flow of paint.
•
Clean the head and the nozzle.
•
Make sure that the paint is not too
dense and dilute if necessary.
•
Remove obstructions.
•
Adjust fluid needle stroke.
0450071
Publicité
