Sunex Tools SX80B Instructions D'utilisation page 4

PLEASE BE SURE TO DO THE FOL LOW ING
• Tighten the gun to the cup securely with the nut and fitting supplied.
• Be sure to have the proper air pres sure at the gun to operate. Proper air pres sure for this tool should not exceed 50 PSI.
• Adjust fluid control screw and spray width adjustment screw to your desired pattern before using on pro duc tion.
• Clean all parts after use.
ADJUSTMENTS
SPRAYING
In normal use, the nozzle wings are
hor i zon tal as shown here. This pro vides a
ver ti cal fan-shaped pat tern which gives
max i mum, even ma te ri al coverage as the
gun is moved back and forth par al lel to the
sur face being fin ished.
SX80B
SX80B_082906.indd 4
FOR BEST PERFORMANCE,
BEFORE USING THIS TOOL
Spray pattern may be in fi nite ly adjusted
from round to flat.
Spray width adjustment screw.
Fluid control screw
Turn right to decrease flow, left to increase.
Set inlet pressure at no more than 50 PSI. For op ti mum
per for mance, some ma te ri als may spray better at PSI
ratings below 50 PSI. If unsure, always test at PSI ratings before
using on final production. Try spray. If it is too fine, de crease
the air pres sure or open fluid control screw. If the spray is too
thick, close the fluid control screw. Reg u late the pat tern width
and repeat ad just ment of spray as needed.
4 rev. 08/29/06
9/5/06 1:38:26 PM