Dometic MagicTouch MT400 Instructions De Montage Et De Service page 11

MT400
7.3 Setting up the convenience function
See fig. d
A
NOTICE! Risk of damage
The maximum output current of 10 A for the convenience function may not be
exceeded.
If you would like to activate larger consumers, you will need to use an additional relay
(operating current relay) with a recovery diode.
You can also set the convenience function to be a "coming home function", for example: during
locking, the dimmed headlight is switched on for 10 sec. The function has to be programmed
(chapter "Programming MagicTouch" on page 17). You can also switch the dipped headlights on
by pressing the "Comfort" button for 10 sec (factory setting). While the convenience function is
running, this can be switched off at any time by pressing the "Comfort" button again.
➤ Connect the pink cable to the original vehicle cable which originates from the light switch and
which connects the positive signal for the dipped headlights (terminal 56b, fig. d).
➤ Negatively-connected dipped headlights (fig. d A):
Connect the brown cable to the vehicle earth (Terminal 31).
➤ Positively-connected dipped headlights (fig. d B):
Connect the brown cable to +12 V (Terminal 30), which must be protected with at least 10 A.
7.4 Vehicle-specific data
A
NOTICE! Risk of damage
Check the polarity before connecting.
The following table does not claim to be exhaustive. You can obtain information on other vehicles
on request from Dometic (see address on the back).
We reserve the right to make alterations.
CL = central locking
EN
Connecting MT400
9