SCHOLTES PP 73 G Mode D'emploi page 14

Before fastening the cooktop in place, position the seal
(supplied) along the perimeter of the countertop, as shown
in the figure 2.
Clamps are provided to fasten the cooktop to counters
measuring from 20 to 40 mm in thickness. To fasten the
cooktop securely, it is recommended that all the clamps be
used.
Fastening Clamps - Assembly Diagram
Clamp Position for
H=30mm top
Clamp Position for
H=20mm top
N.B: Use the clamps contained in the "accessory kit."
Fig. 2
Clamp Position for
H=40mm top
Front
Back
Hobs installation (mod. PP...TF...):
Before fastening the cooktop in place, position the
seal (supplied) along the perimeter of the countertop,
as shown in the figure 3.
Installation of flush-fit hobs
An insulating wooden panel should be fitted beneath the
hob, positioned at a minimum of 20 mm from the hob
underside. This wooden panel must be removable in order
to allow for any maintenance operations beneath the hob.
To slot in the hob flush with the worktop, it is necessary to
lower the area just outside the cut-out for the hob as
illustrated in figure 4.
fig.4
fig.3