Starting The Dishwasher; Remaining Time; Status Light - Atag DW7113XA Manuel D'utilisation

Delayed Start
When you select Delayed Start, the dishwasher will start 1-24 hours after you have pressed the button
Start/Stop and closed the door.
1. Press the button once to activate Delayed Start. Press the button several times – or hold it in –
to set the desired number of hours.
2. Press Start/Stop and close the door. The timer counts down and the dishwasher starts after the
selected delay.
If you want to cancel the Delayed Start option, open the door then press and hold Start/Stop for three
seconds.

Starting the dishwasher

Press Start/Stop until the display shows "Program started". This indicates that the dishwasher is ready
to start. Close the door properly, otherwise the dishwasher will not start.
If the dishwasher is not started or the door is not closed within 2 minutes of the last button press,
the machine switches off.

Remaining time

Once you have selected a program, program mode and options, the time the program took when
last used is displayed.

Status light

The status light at the bottom on the dishwasher provides information by means of 3 different colours.
Status light
Blue - Load more
The program has started, but you can still load more dishes.
Red - Do not load
You should not load more dishes (risk of poorer dishwashing result).
A flashing light indicates that the door has been opened while a program is in progress. If it flashes
when the door is closed, an error has occurred. See the chapter Troubleshooting.
Green - Unload
The dishwashing program is finished. The status light stays on for 15 minutes.
Using the dishwasher
17