Publicité
Les langues disponibles
Les langues disponibles
8 Display
The calculator has a liquid crystal display with 8 digits and special characters. The values that can be shown are
divided into five display loops. All data is retrieved using the push-button next to the display.
At the start you are automatically in the main loop (1st level).
By pressing the push-button longer than 4 seconds you change to the next display loop. Keep the push-button
pressed until you reach the desired information loop.
By pressing the push-button briefly each time you can scan all the information within a loop.
After 2 minutes of non-use of the push-button, the display will automatically be deactivated.
Level 1 / Main Loop:
1) Total heat energy
since start of operation
(standard display);
alternating display:
cooling energy (for
heat/cooling meter);
when negative flow;
information message (if
an error was detected)
5) Current date
alternating with
time
9) Pulse counter 1:
pulse value
alternating with
reading
2)
Page 34 of 79
Article no.: 1080621031
2) Segment test on / off
(all segments triggered
simultaneously)
6) Information message
(alternating binary and
hexadecimal display)
10) Pulse counter 2:
pulse value
alternating with
reading
2)
2022_02_02
3) Last reading date
alternating with
heat energy
(cooling energy),
volume,
value tariff register 1,
value tariff register 2
at last reading date.
1)
(If the meter has 3 pulse
inputs, their values
follow.
2)
)
7) Tariff register 1:
value alternating with
tariff register no. and
criteria
11) Pulse counter 3:
pulse value
alternating with
reading
2)
Subject to technical change! Errors excepted.
4) Total flow volume in m³
8) Tariff register 2:
value alternating with
tariff register no. and
criteria
Publicité
