Publicité
Les langues disponibles
Les langues disponibles
Attention!
When installing, ensure correct positioning regarding the flow by paying attention to the directional arrows on
the connection piece and on the bottom of the plastic adapter. Also, make sure that the blind hole in the plastic
adapter is properly lined up with the metal pin in the inside bottom of the connection piece on the flow outlet.
(In rare cases, this pin may not be present: In this case, it is not necessary for installation.)
Plastic adapter: blind
Directional arrows to match the flow direction
5 Detachable Calculator
We also provide meters with detachable calculators, in order to simplify
mounting in narrow installation spaces. To release the calculator pull it carefully
up off the flow sensor.
For mounting the calculator on the wall, a wall support is latched onto the
adapter of the flow sensor (between calculator and flow sensor). Remove the
calculator. Hold the adapter of the flow sensor and rotate the wall mounting
support anticlockwise until you can release it. Then attach the wall support at the
desired place with the flat surface towards the wall.
We always recommend detaching the calculator from the flow sensor.
However, it is important to note that the calculator must be detached for the following versions:
-
Cooling and heat/cooling meters
-
high temperature heat meter versions
-
high temperature heat/cooling meter versions
Page 32 of 79
Article no.: 1080621031
SensoStar U
(temperature range up to 130 °C)
SensoStar U
(temperature range up to 120 °C).
2022_02_02
Subject to technical change! Errors excepted.
Publicité
