Publicité
Les langues disponibles
Les langues disponibles
BELT ARM ASSEMBLY REPLACEMENT
1. Disconnect air supply
2. Remove rubber belt guard cover and belt
3. Remove the belt arm assembly by removing the arm assembly screw
with 4mm hex key
4. Install new arm assembly
5. Torque to 25 in-lbs
6. Reinstall belt and replace rubber belt guard cover per INSTALLING
SANDING BELT instructions
7. Adjust tracking if necessary
SPEED ADJUSTMENT
1. Turn the regulator knob counter clockwise to reduce speed
2. Turn the regulator knob clockwise to increase speed
3. Feather the speed in any setting via the throttle
ROTATE ARM ASSEMBLY
1. To improve accessibility or improve comfort, rotate the belt arm assembly with the quick lever design
2. Open the lever by pulling out
3. Rotate head to desired position
4. Make sure the arm assembly is tight against the motor housing to maintain belt alignment
5. Close lever by pushing down
6. If arm assembly still rotates, tighten the set screw with a 3mm hex key
MT2618
MT2618 1/2" - 18" AIR BELT SANDER
4
06/25/18
Publicité
