Axis P55 Serie Mode D'emploi page 21

1
Screw
2
Slots for unit holders
3
Safety wire
Note
• Be careful not to damage the cables when connecting them.
• Make sure that the foam gasket holes are aligned with the cable tracks and, if applicable,
remove the cut-out piece for the multi-connector cable from the foam gasket.
4. Connect the network cable and the multi-connector cable (sold separately), if applicable,
to the camera.
5. Turn the cable holders to keep the cables in place.
6. Put the camera base lid back in its original position and tighten the screws (torque
1.5 Nm).
7. Slide the unit holders on the network camera into the slots in the mounting bracket and
rotate the camera unit.
8. Secure the network camera to the mounting bracket by tightening the screws.
Access the Product
AXIS IP Utility and AXIS Camera Management are recommended methods for finding Axis products
on the network and assigning them IP addresses in Windows®. Both applications are free and can
be downloaded from www.axis.com/techsup
The product can be used with most operating systems and browsers. The recommended browsers are
• Internet Explorer
®
• Safari with OS X
TM
• Chrome or Firefox
For more information about using the product, see the User Manual available at www.axis.com
AXIS P55 Network Camera Series
3
® ®
with Windows
®
®
with other operating systems.
21
1
2