Axis P55 Serie Mode D'emploi page 19

Drop Ceiling Mount
1.
Ceiling tile
2.
Diameter of hole 190 mm (7.5 in)
Note
• The combined weight of the camera and ceiling mount is approximately 2.3 kg (5.1 lb.).
Check that the ceiling material is strong enough to support this weight.
• The ceiling tile should be 5-60 mm (0.2-2.4 in) thick.
1. Remove the ceiling tile in which the drop ceiling mount is to be fitted.
2. Use the supplied template to mark the position for the 189.5 mm (7.5 in) hole in the
ceiling tile. Cut around the template.
3. Assemble the ceiling bracket.
4. Place the ceiling bracket on the ceiling tile. See illustration further down.
5. Tighten the bracket arm screws using a torx 20 screwdriver head.
6. Loosen the 4 camera base lid screws and remove the camera base lid. (see Hardware
Overview on page 11).
7. Remove the rubber gasket and route the network cable and the multi-connector cable if
required. Be careful not to damage the cables when connecting to the network camera.
1.
Multi-connector cable
2. Network cable
8. Put the camera base lid back in its original position and fasten the screws.
9. Secure the camera using the supplied safety wire.
AXIS P55 Network Camera Series
19