PEERLESS 32072 Notice page 4

IF FAUCET LEAKS FROM AROUND SPOUT
BODY–Replace O-Rings Repair Kit RP5391
1.
2.
1. SHUT OFF WATER SUPPLIES. Remove handle
with wrench supplied.
2. Unscrew cap assembly and lift out ball and cam
assembly by pulling up on stem.
3. Gently rotate and lift off spout.
4. Cut and remove O-Rings. Stretch new O-Rings
and snap into grooves on body. Reassemble
faucet in reverse order. CAUTION: Be careful
when putting spout back on to gently rotate it
until it rests in escutcheon.
IF SPRAY ATTACHMENT DOES NOT FUNCTION
PROPERLY
1.
2.
4.
1. SHUT OFF WATER SUPPLIES. Remove handle
with wrench supplied.
2. Unscrew cap assembly and lift out ball and cam
assembly by pulling up on stem.
3. Gently rotate and lift off spout.
4. Remove diverter assembly, wash thoroughly and
reinstall. NOTE: If diverter appears damaged,
replace using Repair Kit 5267.
©1999, Masco Canada Ltd.
Inquiries: Peerless Home Products, Inc.
405 Britannia Road East, Suite 212
Mississauga, Ontario L4Z 3E6
IF FAUCET EXHIBITS WATER FLOW
REDUCTION
3.
4.
1. Remove aerator and flush faucet, check for large
debris and replace aerator.
2
IF REDUCED FLOW IS STILL NOTED–Clear
springs of debris and flush system.
1.
3.
1. SHUT OFF WATER SUPPLIES. Remove handle
with wrench supplied.
2. Unscrew cap assembly and lift out ball and cam
assembly by pulling up on stem.
3. Remove seats and springs and any debris
trapped in springs. IMPORTANT: USE
EXTREME CAUTION! Flush lines by opening
water supplies SLIGHTLY! We recommend
placing a bucket over the valve opening to
prevent water spray. Shut off water supplies and
2
reassemble faucet in reverse order.
HELPFUL HINTS:
1. Never tighten cap assembly to stop a leak, always tighten
adjusting ring.
2. Using wrench supplied, partially unscrew adjusting ring before
attempting to remove cap assembly. Always install cap assembly
HAND TIGHT, then tighten adjusting ring.
Faucet
2.
3.
2
4
Consumer Help Line
1-800-263-8050
WRITE PURCHASED MODEL NUMBER
HERE FOR FUTURE REFERENCE.
32072 Rev.-