Instructions For Use - Spencer JET COMPACT HOMECARE Manuel De L'utilisateur

Set-Up
Battery Connection
Allestimento
Collegamento della batteria
- Using a coin or straight-blade screwdriver rotate latch to unlocked position.
- Remove door by pulling up on latch.
- Remove battery from compartment and plug connector into circuit board.
- Replace battery and door; rotate latch to locked position.
- Fully charge battery for 5 hours before using.
Jet Wire
Place canister into wire canister bracket; ensure inlet port marked "Patient" is accessible.
- Attach one end of the connection tubing to connection elbow.
- Insert unit connection elbow into side port.
- Attach other end of connection tubing to side of filter marked "Out".
- The 90° canister elbow connects to the clear side of filter marked "In" and to the top of canister lid marked "Vacuum".
NOTE-Verify clear side of filter marked "In" faces canister.
- Connect patient tubing to canister lid at inlet port labeled "Patient".
- Ensure all connections are secure to prevent leakage in the canister/tubing system.
Jet Compact
- This single-use sealed disposable canister includes an internal filter and fluid shut-off that automatically stops suctioning when it becomes
wet.
- Firmly attach canister by pushing connection fitting straight into the open side port of unit. (Both the top connection fitting and the bottom
support tab secure the canister).
- Securely attach appropriate suction tip to the tubing.

7. INSTRUCTIONS FOR USE

Control Panel Symbols
Power Source Options
AC OPERATION - Plug the 90° power connector of AC to DC adapter/charger into DC power input and attach the line cord. Plug the other end
of AC adapter into a grounded AC supply.
BATTERY OPERATION - Your unit is equipped with a high capacity rechargeable battery. For initial charge on new unit, fully charge the
battery for a minimum of 5 hours (see Battery Charging). To operate unit from the rechargeable battery, ensure that no external power
sources are plugged into the suction unit.
NOTE– During charging or operating, the power supply may become warm to touch; this is normal.
WARNING
If the unit does not receive external power or the battery has not been charged, the low battery indicator light will remain on and the
performance of the unit will drop rapidly. If Low Battery symbol lights, switch to another power source to avoid an interrupted suction
procedure.
How to adjust the vacuum level
1. Once power source is selected, turn the unit on by pressing the "On" button. The GREEN light, indicating external power, will remain lit
when external power is connected.
2. Occlude (block) the patient end of the tubing, then adjust vacuum level from 50 to 550 mmHg by turning the vacuum regulator knob
clockwise to increase and counter-clockwise to decrease the vacuum. Release and occlude once more to confirm setting. The desired level of
vacuum can be viewed on the LED display.
NOTE–The LEDs have two brightness levels. As the vacuum level is adjusted, the LEDs will illuminate in progression. When an LED is at half
brightness, it indicates that the vacuum level is halfway between the previous fully lit LED and the half brightness LED. EXAMPLE: If the 150
18