Safety Information; Unpacking; Theory Of Operation; Ventilation - Desa TC100 Manuel D'utilisation

SAFETy INFORMATION

Continued
12. Use only the factory preset regulator provided
with the heater.
13. Check heater for damage before each use. Do
not use a damaged heater.
14. Do not alter heater. Keep heater in its original
state.
15. Do not use heater if altered.
16. Locate heater on stable and level surface if
heater is hot or operating.
17. Not intended for use on finished floors.
18. Never block air inlet (bottom of shell) or air
outlet (around top of shell) of heater.
19. Do not leave heater unattended.
20. Keep children and animals away from
heater.
21. Never move, handle or service a hot or operat-
ing heater. Severe burns may result. You must
wait 15 minutes after turning heater off.
22. To prevent injury, wear gloves when handling
heater.
23. Never attach duct work to heater.
24. Turn off gas supply to heater when not in use.
25. Use only original replacement parts. This
heater must use design-specific parts. Do
not substitute or use generic parts. Improper
replacement parts could cause serious or fatal
injuries.

UNpACkING

1. Remove all packing items applied to heater
for shipment. Keep plastic cover caps for
storage.
2. Remove all items from carton.
3. Check all items for shipping damage. If heater
is damaged, promptly inform dealer where you
bought heater.

THEORy OF OpERATION

The gas supply attaches to the
The Fuel System:
heater by a minimum 3/4" i.d. hose or flexible
connector. User must supply hose or flexible con-
nector. The length should be no more than 10 feet
long. The natural gas moves through the regulator
and out the nozzle.
The Ignition System:
pilot. The pilot lights the main burner.
The Automatic Control System:
the heater to shut down if the flame goes out.
118535-01A
The piezo ignitor lights the
This system causes
www.desatech.com

VENTILATION

WARNING: Provide at least a
3 square foot (0.28 m
fresh, outside air while running
heater. If proper fresh, outside
air ventilation is not provided,
carbon monoxide poisoning
can occur. Provide proper fresh,
outside air ventilation before
running heater.
pRODUCT
IDENTIFICATION
Ignitor
Button
Control
Knob Button
Figure 1 - 100,000 Btu Model Heater

NATURAL GAS SUppLy

You must provide the natural gas supply and the
connections to the heater.
The natural gas supply must have a capacity of 100
scfh at 6" water column to 14" water column.
Consult your natural gas supplier for proper sizing
of the natural gas supply lines.
Follow all local ordinances and codes. In the ab-
sence of local ordinances and codes, refer to the
National Fuel Gas Code Handbook, NFPA54/ANS
Z223.1 and the Natural Gas Installation Code,
CAN/CGA B149.2.
) opening of
2
Outer
Shell
Regulator
Heater
Inlet
3