Every Day; Checking For Wear - Atlas Copco 34WS-6 Prescriptions De Sécurité Et Instructions Pour L'opérateur

Safety and operating instructions

Every day

Before undertaking any maintenance or changing
the insertion tool on pneumatic machines, always
switch off the air supply and bleed the machine by
depressing the start and stop device then disconnect
the air hose from the machine.
♦ Clean and inspect the machine and its functions
each day before the work commences.
♦ Conduct a general inspection for leaks and
damage.
Check that the air inlet nipple is tightened and that
♦
the claw coupling is free from damage.
Check the function of the throttle handle. Make
♦
sure that it moves freely up and down.
Check the function of the retainer. Make sure that
♦
it locks the drill steel.
Change damaged parts immediately.
♦
Replace worn components in good time.
♦
♦ Check the through bolts of the machine. Make
sure that they are tightened.
♦ If the machine is equipped with a silencer, check
for damage.
20

Checking for wear

1. Check the wear in the chuck bushing using the
Atlas Copco (3091 0038 00) gauge (22 mm).
If the wear limit has been exceeded, the drill steel
shank will wear more quickly, or become
deformed. This will lead to stoppages and
increased drill-steel consumption.
2. Check the tightness of the side-bolt nuts
(A).Tighten to a torque of 130 Nm.
3. Check the tightness of the throttle lever. Tighten
to a torque of 60 Nm.
4. Check the rock drill's connection to the pusher
leg.
5. Check the hoses, couplings and controls for
leakage and damage.
© 2015 Construction Tools PC AB | No. 9800 0829 71c | 2015-10-07
BBC 34WS-6, 34WS-8
Original instructions