PowerWalker VI 400 SC Guide De Démarrage Rapide page 7

IV: Connect Modem or Phone for Surge Protection
Connect a single modem or phone line into surge-protected "IN" outlet on the back panel of the
UPS unit. Connect from "OUT" outlet to the computer with another phone line cable.
V: Connect USB Cable
To monitor the UPS status, such as unattended UPS shutdown and start-up, by using bundled
software, please connect the UPS and PC with USB cable included.
NEVER connect a laser printer or scanner to
the UPS unit because in-rush current generated by
motor's devices may cause the damage of the unit
VI: Turn On/Off the Unit
Turn on the UPS unit by pressing the power switch. Turn off the UPS unit by pressing again the
power switch.
6. Audible alarm from the UPS

When UPS switches from AC mode to Battery Mode to back up power supply: sounding
every 10 seconds

When battery is low: sounding every second

When UPS is overloaded: sounding every 0.5 second

When battery is faulty: sounding every 2 seconds

Other fault: Continuous sounding
7. Software Installation on your PC

Please download the newest software from http://viewpower.powerwalker.com. Then, follow
the on-screen instructions to install the software ViewPower.

After the software is successfully installed, the communication with UPS has been established
and an orange icon will appear in the system tray.

Double-click the icon to use the monitor (as above).

You can schedule UPS shutdown/start-up and monitor UPS status through PC.

Detail instructions please refer to the e-manual in the software.
EN