Greenlee Intelli-PUNCH Mode D'emploi page 8

Setup and Operation (cont'd)
STAINLESS STEEL
Note: Refer to "Capacity and Draw Stud Selection Guide"
on page 12 for capacity, draw stud, and hardware.
Punching Stainless Steel
• 1/2" Conduit Size
(dia. 0.885" / 22.5 mm)
Punching Stainless Steel
• 3/4" to 3" Conduit Size
(dia. 1.115" to 3.539" /
28.3 mm to 89.9 mm)
Punching Stainless Steel
• 3-1/2" to 4" Conduit Size
(dia. 4.011" to 4.544" /
102.7 mm to 115.4 mm)
Greenlee / A Textron Company
Material
Being Punched
1/2" (12.7 mm)
Pilot Hole
Punch
Material
Being Punched
7/8" (22.2 mm)
Pilot Hole
Punch
Material
Being Punched
ø 1-3/8" (34.6 mm)
Pilot Hole
1557SS
Sleeve
Punch
8
Intelli-PUNCH™ Knockout Driver
29451
Draw Stud
Die
29452
Draw Stud
Die
29452
Draw Stud
Die
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
1924AA Spacer
(3/4"–1-1/4" only)