Pearl POL PILOT 6000 Mode D'emploi page 42

Step 6
If you would like to install e.g. kindergartens to be warned of
these locations, you would fi nd them under the menu item
„Institutions" in the submenu „Care".
Once you have completed your selection, simply click on the
yellow button to start transferring your selection to the POI
Pilot 6000.
ATTENTION: The download that follows may take
some time. Please do not under any circumstances
abort this process.
42
Step 7
Complete update of the POIbase software.
ATTENTION: The extensive data and firmware
update that follows may take up to approx. 30
minutes (!!!).
During installation, do not connect or disconnect any
other USB device to the PC (this can lead to problems
and make repetition of the installation necessary).
Step 8
After complete installation, you can disconnect the POI Pilot
from the PC via USB cable. On the display, the POI Pilot now
shows you that the POI data is being loaded and afterwards
restarts by itself. The pilot is now ready for use and can be
used in a motor vehicle or on a motorcycle.
NOTE: The acoustic warning signal for mobile speed
cameras is disabled by default. In order to be alerted
of mobile speed cameras through an acoustic signal,
this feature must be activated beforehand.