Conrad Electronic Raveland XCA 700 37 96 41 Notice D'emploi page 32

For connecting the cinch inputs, use only shielded cinch cables
suitable for this purpose. The use of any other cable may cause
interference.
Keep the length of the connection cables as short as possible.
Do not install the cables in the proximity of other cables. Thus, you
avoid interface at the amplifier input.
To avoid distortion or faulty fittings and possible damage to the
amplifier always make sure that the cinch inputs are connected to
sources which are provided with a cinch output and that the loud-
speaker inputs of the XCA 700 model are only connected to loud-
speaker outputs. When doing this, observe also the connection data
in the section „Technical Data".
Model XCA 1200/1600
Connect the cinch outputs of your car
radio to the cinch connections INPUT (7)
of the amplifier.
32
rear outputs
> connection REAR INPUT
front outputs
> connection FRONT INPUT
Observe the coloured right-left marking
of the cinch connections:
white or black > left
red > right
If your car radio does not have 4 pre-
amplifier outputs please use the so
called Y-adapter.