Connecting The Power Supply - Conrad Electronic Raveland XCA 700 37 96 41 Notice D'emploi

Good places for installation are the luggage boot and the free space under the seats.
Make sure that the amplifier can be accessed in such a way that it can be connected
to the electrical system.
A favourite place of installation is also the bulkhead between the luggage
boot and the passenger compartment. Install the device in such a manner
that the cooling ribs of the housing are in a vertical position. This ensures a
better air circulation around the housing.
• Mark the holes for the screws at the place of installation. For doing this, use the
device as a pattern.
• Drill the holes for the fastening screws.
• Fasten the amplifier by the two screws delivered.

Connecting the Power Supply

The electric connection should always be performed by a specialist.
To avoid short circuits and resulting damages to the device the neg-
ative terminal (ground) of the car battery is to be disconnected first.
Before reconnecting the negative terminal to the battery, ensure
that the amplifier has been completely connected.
29