Important Safety Information - Textron Company GREENLEE 882 Manuel D'instructions

IMPORTANT SAFETY INFORMATION

This symbol is used to call your attention to hazards
or unsafe practices which could result in an injury or
property damage. The signal word, defined below,
indicates the severity of the hazard. The message
after the signal word provides information for pre-
venting or avoiding the hazard.
Immediate hazards which, if not avoided, WILL result
in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
Read and understand all of the
instructions and safety information
in this manual before operating or
servicing this tool.
Failure to observe this warning could
result in severe injury or death.
Pinch points:
Keep hands away from bending shoe,
follow bar, saddle, and conduit when
bender is in use.
Greenlee / A Textron Company
SAFETY
ALERT
SYMBOL
882 and 882CB Hydraulic Benders
Wear eye protection when operating
this tool.
Failure to wear eye protection could
result in serious eye injury from flying
debris and hydraulic oil.
• Do not stand in direct line with the hydraulic ram. A
component failure could propel parts with sufficient
force to cause severe injury or death.
• Do not operate while wearing loose clothing. Loose
clothing could get caught in moving parts.
Failure to observe these warnings could result in
severe injury or death.
• Conduit moves rapidly as it is bent. The path of
the conduit must be clear of obstructions. Be sure
clearance is adequate before starting the bend.
• Inspect the bender, pump, and hose before each
use. Replace damaged, worn or missing parts with
Greenlee replacement parts. A damaged or improp-
erly assembled component could break and strike
nearby personnel.
• Some of the bender parts and accessories are
heavy and may require more than one person to lift
and assemble. Improper lifting can result in back
injury.
Failure to observe these precautions may result in
injury or property damage.
Make sure all hose fittings are properly seated before
starting the bend. Incomplete connections may not
allow the ram to retract after the bend is complete.
Note: Keep all decals clean and legible, and replace
when necessary.
3
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070