LG LSEL6337 Serie Manuel D'utilisation page 12

12 INSTALLATION
Choosing the Proper
Location
Electricity
The range should always be plugged into its own
individual properly grounded electrical outlet.
• This prevents overloading house wiring circuits
which could cause a fire hazard from overheated
wires.
• It is recommended that a separate circuit
serving only this appliance be provided.
Electrical Connection Requirements
The range must be installed in accordance with
Local and Canadian Electrical Codes (latest
edition). See rating plate for total connected Amp
rating. This model was shipped direct from the
factory with Service cord attached. There are no
range connections necessary.
NOTE
• Only a range cord rated at 40 amps with 120/240
minimum volt range is required. If a 50 amp
range cord is used, it should be marked for use
3
with 1 / " diameter connection openings.
8
Flooring
CAUTION
• Use an insulated pad or 1/4 in. (0.64 cm) plywood
under the range if installing the range over
carpeting.
Ambient Temperature
CAUTION
• Make sure wall covering, countertop and
cabinets around the range can withstand the
heat (up to 194 °F) generated by the range.
Discoloration, delamination or melting may
occur. This range has been designed to comply
with the maximum allowable wood cabinet
temperature of 194 °F.
• Before installing the range in an area covered
with linoleum or other synthetic floor covering,
make sure the floor covering can withstand
temperatures of at least 200 °F (93 °C).
Additional Installation
Requirements
Mobile Home
The installation of this range must conform to the
Manufactured Home Construction and Safety
Standard, Title 24 CFR, Part 3280 (formerly the
Federal Standard for Mobile Home Construction
and Safety, Title 24, HUD Part 280), or when such
standard is not applicable, the Standard for
Manufactured Home Installations, ANSI A225.1/
NFPA 501A or with local codes.
• When this range is installed in a mobile home, it
must be secured to the floor during transit. Any
method of securing the range is adequate as
long as it conforms to the standards listed
above.
• A four-wire power supply cord or cable must be
used in a mobile home installation.