HIKVISION DS-KH8350-TE1 Guide Rapide

DS-KH8350-(W)TE1
Network Indoor Sta on UD20185B
ENGLISH
Diagram References
1 Appearance
1 1
Screen Screen 2 Microphone 3 Unlock Key 4 Loudspeaker 5 SD Card Slot
6 Debugging Port 7 Network Interface 8 Power/Alarm Terminal
Note: The appearance of the device varies according to different models. Refers to the actual device for
detailed informa on.
2 Terminal and Wiring
There are 20 pins in the terminal on the rear panel of the indoor sta on: 2 RS-485 pins, 2
power pins, 2 alarm output pins, 8 alarm input pins, and 4 reserved pins.
3 Installa on
It supports wall moun ng.
Installa on Accessory Descrip on
The wall moun ng plate is required when installing the indoor sta on on the wall.
The dimension of wall moun ng plate is shown.
Wall Moun ng
Before You Start
Make sure the device in the package is in good condi on and all the assembly parts
are included.
The power supply the indoor sta on supports is 12 VDC. Please make sure your
power supply matches your indoor sta on.
Make sure all related equipments are power-off during the installa on.
Check the product specifica on for the installa on environment.
1. Fix the wall moun ng plate to the wall with supplied screws.
2. Put the indoor sta on on the holder of the wall moun ng plate.
4 Ge ng Started
1
Ac vate Indoor Sta on
You are required to ac vate the device first by se ngs a strong password before you
can use the device.
1. Power on the device. It will enter the ac va on page automa cally.
2. Create a password and confirm it.
3. Tap OK to ac vate the indoor sta on.
2
Quick Configura on
1. Choose Language and tap Next.
2. Set network parameters and tap Next.
- Edit Local IP, Subnet Mask and Gateway parameters.
- Enable DHCP, the device will get network parameters automa cally.
3. Configure the indoor sta on parameters.
- .Select Indoor Sta on and tap Next to link main door sta on.
a. Edit Floor and Room No.
b. Create and confirm SIP register password.
Note: If you want to add the indoor sta on to the door sta on, the SIP password of the indoor sta on
should be the same as the registra on password of the door sta on.
c. Tap Advanced Se ngs to edit Community No, Building No. and Unit No.
d. Op onal: Enable Indoor Sta on Se ngs and select the indoor sta on to link.
- . Select Indoor Extension and tap Next to link indoor sta on.
a. Edit No., Room Name.
b. Create and confirm SIP register password.
4. Linked related devices and tap Next. If the device and the indoor sta on are in the
same LAN, the device will be displayed in the list. Tap the device or enter the serial No.
to link.
a. Tap the se ngs icon to pop up the Network Se ngs page.
b. Edit the network parameters of the door sta on manually or enable DHCP to get
the network parameters automa cally.
e. Tap OK to save the se ngs.
5. Tap Finish to save the se ngs.
Refers to Video Intercom Network Indoor Sta on Configura on Guide (Scan the QR code) for details.
Refers to Video Intercom Network Indoor Sta on Opera on Guide (Scan the QR code) for details.
1 1
2
2
3
95
60
1
3 4
4.6
Unit：mm
15.3
6
5
Scan the QR code to get the Configura on Scan the QR code to get the Opera on Guide
Guide for detailed informa on. for detailed informa on.
Screw
Screw
Installa on Part
Indoor Sta on
7
8
Wall