Troubleshooting - Ecco 10 Serie Instructions D'installation Et D'utilisation

LEDs
12V Front/Rear LED Lighthead to suit all Series (x: A = Amber, B = Blue, R= Red, W= White)
12V Front/Rear LED Lighthead to suit all Series (x: A = Amber, B = Blue, R= Red, W= White)
12V Corner LED Lighthead to suit 10 and 20 Series (x: A = Amber, B = Blue, R= Red, W= White)
12V Corner LED Lighthead to suit 15 and 30 Series (x: A = Amber, B = Blue, R= Red, W= White)
12V Corner LED Lighthead to suit all Series (x: A = Amber, B = Blue, R= Red, W= White)
24V Front/Rear LED Lighthead to suit all Series (x: A = Amber, B = Blue, R= Red, W= White)
24V Corner LED Lighthead to suit 10 and 20 Series (x: A = Amber, B = Blue, R= Red, W= White)
24V Corner LED Lighthead to suit 15 and 30 Series (x: A = Amber, B = Blue, R= Red, W= White)
Driver Modules / Controller / Strobe Packs
12V/24V LED Driver Module (x: 4 = 4 Head, 8 = 8 Head, 20 = 20 Head)
12V/24V Halogen Driver Module
Control Panel to suit In-Bar Director all Series
Strobe Power Supply 2 Head Quad Flash
Strobe Power Supply 4 Head Double and Quad Flash
Strobe Power Supply 4 Head Double, Quad and Quin Flash
Strobe Power Supply 6 Head Double, Quad, Quin and Mega Flash
Screws / Latches
Lens Wire Latch to suit 10 and 15 Series Center Lenses
Lens Wire Latch to suit 20 and 30 Series Light Bars also for 10 Series End Lens
Centre Section Spring Clip
Lens Screw to suit 10 Series End Lens
Lens Screw to suit 15 Series End Lens
Lens Screw to suit 30 Series End Lens

Troubleshooting:

All lightbars are thoroughly tested prior to shipment. However, should you encounter a problem during installation or during the life of the product, follow the
guide below for troubleshooting and repair information. If the problem cannot be rectified using the solutions given below, additional information may be
obtained from the manufacturer – contact details are at the end of this document.
ROTATORS
PROBLEM
Does not operate
Rotates but does not illuminate
Illuminates but does not rotate
Does not maintain correct speed
STROBE LIGHTS
PROBLEM
No strobes operate
One strobe head does not flash
Fuse blows repeatedly
920-0052-00 Rev. F
POSSIBLE CAUSE
Blown fuse
No power
Blown bulb
Failed motor
Failed motor
POSSIBLE CAUSE
No power to power-supply
No control signal(s)
Failed strobe-tube
Failed power-supply
SOLUTION
Check wiring, replace fuse
Check control switches
Replace bulb
Replace rotator unit
Replace rotator unit
SOLUTION
Check fuses and red/black wires to strobe power-supply.
Check for power on colored control wires
Check strobe head by connecting to a different output from the
power-supply
Replace power-supply
R109-924x
EZ0001x
R109-938x
R159-938x
EZ0002x
R109-924x-24
R109-938x-24
R159-938x-24
R209-937-x
R209-937-H
R824-007
R819-001
R819-002
R819-003
R819-004
R109-927
R209-927
R209-921
R109-942
R159-942
R309-942
Page 15 of 17