Ecco 10 Serie Instructions D'installation Et D'utilisation page 11

Bulb Replacement
!
WARNING!
Halogen bulbs are extremely hot! Allow to cool completely before attempting to remove. Gloves and eye protection should be
worn when handling halogen lamps as they are pressurized and accidental breakage can result in flying glass.
H3 Bulb:
1. See "Lens Removal" for instructions on removing and replacing lenses.
2. Disconnect the spade connector on the wire connecting to the bulb.
3. Remove the retaining screw at the rear of the H3 bulb. If access to the retaining screw is limited by other
components of the lightbar, remove the halogen lens but take care to replace all screws and washers as
originally installed.
4. Lift the globe out and replace with an equivalent H3 bulb (35W max). Do not touch the glass portion of the
bulb – natural skin oils can cause premature bulb failure.
5. Use the retaining screw to fix the bulb in position.
6. Reconnect the spade connector on the wire to the bulb.
7. Power up and test the system before replacing the lenses.
Alley / Takedown
The Alley / Takedown lights are fixed halogen lights which are mounted in the 10, 15, 20 and 30 Series Lightbars. They are available in 12V
and 24V versions.
10, 20 Series (H1 Bulb)
920-0052-00 Rev. F
15, 30 Series (MR8 Bulb)
15, 30 Series (H3 Bulb)
Page 11 of 17