Ecco 10 Serie Instructions D'installation Et D'utilisation page 10

!
WARNING!
Halogen bulbs can be extremely hot! Allow to cool completely before attempting to remove. Gloves and eye protection should
be worn when handling halogen lamps as they are pressurized and accidental breakage can result in flying glass.
Consider changing all of a specific bulb type when one burns out. This will minimize removal and replacement of outer lenses.
H1 Bulb:
1. See "Lens Removal" section for instructions on removing and replacing the outer lightbar lenses.
2. Rotate the Cleversector to get best access to the back of the reflector.
3. Disconnect the flag terminal from the back of the bulb.
4. Release the bulb retaining spring and extract the H1 bulb.
Note orientation of globe (chamfered section of base) during removal – it will only fit one way.
5. Install new bulb, ensuring correct orientation noted above.
Do not touch the glass section of the bulb - natural skin oils can cause premature bulb failure.
6. Re-secure the retaining clip.
7. Reconnect the flag terminal to the back of the bulb.
8. Power up and test the system before reinstalling the lightbar lenses.
LED
The LED lightheads have been designed to ensure long service life using high performance
LEDs rated to thousands of hours of operation and having no moving parts. The modules are
low profile units that have a high intensity output with low current draw. There are different
types of mounting brackets to suit different locations in the lightbar. LED lightheads are not
user serviceable.
LED safety directors are also available. For more information refer to the "Safety Director"
section.
Halogen Flashers
Halogen flashers are used as an auxiliary warning device and are mounted in the lower level of
10, 15, 20 and 30 Series Lightbars. Each halogen flasher drives two light-heads with an
alternating flash pattern operating at 54 flashes per minute. It is available in 12V and 24V
versions.
920-0052-00 Rev. F Page 10 of 17