Cobra microTALK GA-CC Instructions page 2

Operation
Intro
Batteries
ns
Intro Operation
These rechargeable batteries must be recycled or disposed of properly in compliance with
Secondary Icons
all applicable laws. They may not be thrown in the trash. Certain states or municipalities
require recycling and have established collection programs. Please contact your local waste
removal authority for instructions, or return to Cobra for recycling. Wrap batteries carefully
and mail postage prepaid to: Cobra Electronics Corporation, 6500 West Cortland Street,
ry Icons
Chicago, IL 60707 USA, Attn: Battery Recycling.
Important
Notice
mportant
Insert Radio(s)
The charge indicator light will stay on as long as the radio is in the charging well, even after
the batteries are fully charged.
It normally takes about 15 hours to fully recharge batteries. Batteries will not be damaged if
they stay in the charging well longer than that. Not all radio models include charge contacts.
Each port can charge one radio. Uses 120 Volt adapter. Use only Cobra NiMH batteries,
model GA-3ANH with charger model GA-CC.
Cobra recommends your radio is turned off while being charged.
Customer Assistance
For Assistance in the U.S.A. or Canada
Customer Assistance Operators
English and Spanish. 8:00 a.m. to 6:00 p.m. CT, Monday through Friday (except holidays) 773-889-3087 (phone).
Questions
English and Spanish. Faxes can be received at 773-622-2269 (fax).
Technical Assistance
English only. www.cobra.com (on-line: Frequently Asked Questions).
English and Spanish. productinfo@cobra.com (e-mail).
For Assistance Outside the U.S.A., Canada or in French
Contact Your Local Dealer
English
Desktop Charger and
Rechargeable Batteries
Operation
Desktop Charger
and Rechargeable Batteries
To insert in radio:
1. Remove belt clip and battery cover (in back of radio).
2. Insert GA-3ANH batteries according to polarity markings.
Estimated operation time on full charge: 12 hours
Customer Warranty
Assistance
Do not put batteries into fire or expose to high heat.
They may explode.
Notice
For charging Cobra's microTALK
1. Insert radio(s) as shown.
2. Insert round connector of 120 volt adapter into jack on back
of charger.
3. Plug 120 volt adapter into electrical outlet.
If charging light is not on , check position of radio. Radio should
be upright.
Customer Warranty
Assistance
Cobra ® , microTALK
trademarks of Cobra Electronics Corporation, USA.
® radio(s):
® and snake design are registered
•