Troubleshooting - Ryobi RY40204 Manuel D'utilisation

PROBLEM
Line will not advance when
using the auto-feed head
Grass wraps around boom
housing and string head
Motor fails to start when switch
trigger is depressed
All manuals and user guides at all-guides.com

TROUBLESHOOTING

POSSIBLE CAUSE
Line is welded to itself.
Not enough line on spool.
Line is worn too short.
Line is tangled on spool.
Cutting tall grass at ground
level.
Battery is not secure.
Battery is not charged.
Shaft not connected
completely
For any questions about operating or maintaining your product,
Your product has been fully tested prior to shipment
to ensure your complete satisfaction.
11 — English
Lubricate with silicone spray.
Install more line. Refer to Line Replacement earlier in
this manual.
Pull line while pressing button.
Remove line from spool and rewind. Refer to Line
Replacement earlier in this manual.
Cut tall grass from the top down to prevent wrapping.
To secure the battery pack, make sure the latch on the
bottom of the battery pack is snapped into place.
Charge the battery pack according to the instructions
included with your model.
Make sure shaft trimmer is securely seated in the coupler
on the power head.
CALL US FIRST
call the Ryobi Help Line!
SOLUTION