Hamilton Beach 63245 Manuel D'instructions page 5

How to Assemble and Grind
w WARNING
Moving Parts Hazard.
To reduce the risk of personal
injury, always unplug mixer
before inserting or removing
accessories.
NOTE: Make sure no bowl
attachment (such as flat beater,
whisk or dough hook) is installed.
Never operate Stand Mixer with
both Power Hub Accessory and
Bowl Attachment connected.
4. Insert Accessory straight into Power
Hub Opening, aligning Tab on
Accessory with Tab Opening near
Power Hub Knob. Turn Power Hub
Knob clockwise to tighten and hold
Accessory in place.
1. Before inserting Accessory, make
sure Stand Mixer is unplugged
and Stand Mixer Speed Control
Dial is set to OFF ( ).
5. To assemble Seal Assembly, place Washer with raised area
into Seal Ring until parts are flush. With Seal Ring side facing
Auger, slide Seal Assembly onto Auger Shaft. Slide Shaft of
Grinding Auger into Housing with Auger Pin facing out.
6. Place Blade on Auger Pin, aligning square side of Blade with
square on Auger Pin.
2. Lift up Power Hub Cover and
let rest on Mixer Head.
3. Turn Power Hub Knob
counterclockwise until screw
cannot be seen in Power Hub
Opening.
7. Place desired Plate on Auger
Pin, aligning notch on Plate
with notch on end of Grinder
Accessory.
5