Bostitch EHF1838K Manuel D'instructions Et D'entretien page 7

189854RB_EHF-LHF_Manual_189854RB_EHF-LHF_Manual 2011/6/29 下午 2:58 Page 7
EYE PROTECTION which conforms to ANSI specifications and provides protection against
flying particles both from the FRONT and SIDE should ALWAYS be worn by the operator and
others in the work area when connecting to air supply, loading, operating or servicing this
tool. Eye protection is required to guard against flying fasteners and debris, which could
cause severe eye injury.
The employer and/or user must ensure that proper eye protection is worn. Eye protection
equipment must conform to the requirements of the American National Standards
Institute, ANSI Z87.1 and provide both frontal and side protection. NOTE: Non-side shielded
spectacles and face shields alone do not provide adequate protection.
TO PREVENT ACCIDENTAL INJURIES:
• Never place a hand or any other part of the body in nail discharge area of tool while
• Never point the tool at anyone else.
• Never engage in horseplay.
• Never pull the trigger unless nose is directed at the work.
• Always handle the tool with care.
• Do not pull the trigger or depress the trip mechanism while loading the tool.
LOADING THE EHF1838K & LHF2025K
1.Depress magazine release button and
pull back magazine.
2.Open magazine fully and turn tool
sideways with discharge area pointed
away from yourself and others. Load
staples in channel.
3.Push magazine forward until latch is
engaged.
LOADING THE EHF1838K & LHF2025K
the air supply is connected.
-7-