Maintenance Checklist - Bostitch EHF1838K Manuel D'instructions Et D'entretien

189854RB_EHF-LHF_Manual_189854RB_EHF-LHF_Manual 2011/6/29 下午 2:58 Page 13
Maintenance
Inspect trigger performance
Drain condensation from air
compressor tanks and air
filters (if present)
Clean magazine assembly
Clean nose assembly
Ensure all fasteners remain
tight
Check/clean air inlet air filter
Replace swivel air fitting
Replace piston/driver
assembly
Replace O-rings
Replace bumper
Replace headvalve
Replace engine cylinder
Benefit
Ensure trigger system is in Refer to Tool Operation
proper working order Check section in this manual
Prevents accumlation of Open drain cock on tanks
moisture that can impede tool and air filters and drain all
performace condensate
Prevents accumlation of Blow clean with compressed air
debris that could cause a jam
Prevents accumlation of Blow clean with compressed air
debris that could cause a jam
Prevent loose parts Tighten all fasteners with
appropriately sized hex
wrench
Maintains proper air flow to Remove end cap and use
engine for peak performance. compressed air blow gun to
blow filter clean. Replace filter
as required.
Maintains proper air flow to Remove worn swivel air fitting
engine for peak performance and replace with new swivel
fitting
Maintains consistent drive Refer to replacement part kit
quality instructions
Maintains engine for peak Refer to replacement part kit
performance instructions
Maintains engine for peak Refer to replacement part kit
performance instructions
Maintains engine for peak Refer to replacement part kit
performance instructions
Maintains engine for peak Refer to replacement part kit
performance instructions
-13-

MAINTENANCE CHECKLIST

Procedure Service Interval
Daily
Daily
Daily
Daily
Weekly
25,000 Fasteners, or monthly
- if used in dusty location
50,000 Fasteners
150,000 Fasteners
250,000 Fasteners
250,000 Fasteners
250,000 Fasteners
500,000 Fasteners