Assembly - Ryobi P2107 Manuel D'utilisation

UNPACKING
This product requires assembly.
 Carefully remove the product and any accessories from
the box. Make sure that all items listed in the packing list
are included.
WARNING:
Do not use this product if any parts on the Packing List
are already assembled to your product when you unpack
it. Parts on this list are not assembled to the product by
the manufacturer and require customer installation. Use
of a product that may have been improperly assembled
could result in serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 Do not discard the packing material until you have care-
fully inspected and satisfactorily operated the product.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.
PACKING LIST
18 Volt Dual Power Blower
Blower Tube
High Velocity Nozzle
Operator's Manual

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories not recommended for use with this product.
Any such alteration or modification is misuse and could
result in a hazardous condition leading to possible serious
personal injury.
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack or unplug
the power source from the product when assembling
parts.
ATTACHING THE BLOWER TUBE AND HIGH
VELOCITY NOZZLE
See Figure 2.
 Slide blower tube onto blower housing until the button
on the blower housing clicks into the slot on the tube.
 To remove, depress the button on the blower housing
and remove the tube.
 The high velocity nozzle on the end of the blower tube can
be removed to allow a larger area to be covered during
blower operation. To remove, lift the flap and slide the
nozzle off. To reinstall, slide nozzle on tube until the tab
on the blower tube snaps into the slot on nozzle flap.
8 — English