Bosch JS572E Consignes D'utilisation/De Sécurité page 9

measures reduce the risk of starting the tool accidentally.
Blade Installation and
Removal
This jigsaw is equipped with a Bosch
tool-less blade changing system for fast
and easy changes of T-shank blades.
Note: This jigsaw does not accept U-
shank blades.
If blade is not properly installed, then
the blade may unexpectedly dislodge
from jigsaw when tool is energized.
1. To remove a previously-used blade, pull
blade change lever until blade ejects (Fig.
2).
Blade ejects forcefully when released.
Direct away from yourself or bystanders.
2. Pull the blade change lever to the point
that the notch on the blade clamp's ring
line up with the slot in the center of the
clamp (Fig. 2).
DOUBLE ROLLER
GUIDE
BLADE
FIG. 2
Disconnect the plug from the power source before making any
assembly, adjustments or changing accessories. Such preventive safety
NOTCH
BLADE CLAMP RING
Assembly
3. Insert the saw blade (teeth in cutting
direction) until it the "T" part of the blade
shank is completely inserted in to the
blade clamp. (When inserting the saw
blade, the back of the blade must rest in
the grooves in double roller guide Fig. 3.)
4. When blade change lever is released, it
will spring back to its closed position.
5. Verify that the blade clamp has also
returned to its closed position (which is
the point where slots were previously).
Note: If the saw blade cannot be
inserted into the plunger, the slots of
the blade holder are not in the correct
position.
Precision Control
The double roller guidance system helps
to ensure minimal blade deflection.
FIG. 3
BLADE
CHANGE
LEVER
SLOT
-9-
BLADE
BLADE CHANGE
LEVER