Tripp-Lite SmartOnline SU3000RTXL2U Manuel D'utilisateur page 9

4. Installation
External Battery Connection
3
Check to ensure the external batteries being
connected match the voltage listed on the UPS
battery connector. Adding external batteries will
increase recharge time as well as runtime. See
the battery pack owner's manual for complete
installation instructions. Make sure cables are
fully inserted into their connectors. Small sparks
may result during battery connection; this is
normal. Do not connect or disconnect battery
packs when the UPS is running on battery power.
Tripp Lite SMART Battery Packs include a wired
data connection that enables automatic detection
and configuration for up to 6 SMART Battery
Packs to the UPS. Tripp Lite Legacy NON-SMART
battery packs are also supported for extended
runtime applications. For External battery
configuration, see Section 5.7: Configuring
External Battery Packs for options and
configuration methods.
Accessory Card Slot
4
The slot accommodates an optional internal
accessory card (model WEBCARDLX, sold
separately). WEBCARDLX provides an Ethernet
network interface for remote monitoring and
control of the UPS system via SNMP , Web, SSH or
telnet. WEBCARDLX enables remote reboots,
shutdowns, load monitoring, condition reporting
and more.
Remove the cover panel from the slot to insert
the accessory card. Refer to the WEBCARDLX
documentation for additional installation
instructions.
17-04-276 9335AA.indb 9
3
4
9
5/1/2017 1:24:42 PM