Table Des Matières; Safety Information - ETI GROW ELITE GEGH-600W-FS Guide D'utilisation Et D'entretien

table of Contents
Table of Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Safety Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Warranty . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Pre-Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Planning Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3

safety information

warninG: Carefully read and understand the information
given in this manual before beginning the assembly and
installation. Failure to do so so could lead to electric shock,
fire, or other injuries which could be hazardous or even fatal.
warninG: Ensure the electricity to the wires you are
working on is shut off. Either remove the fuse or turn off the
circuit breaker
.
warninG: This product must be installed in accordance
with the applicable installation codes by a person familiar with
the construction and operation of the product and the hazards
involved.
WARNING: minimum required distances (200 mm) between
adjacent lighting equipment and between the lighting
equipment and combustible materials such as walls, ceilings,
movable partitions
CaUtion: To prevent eye damage, avoid looking directly at
the unshielded LEDs.
CaUtion: Ensure the fuse or circuit breaker provides
sufficient amperage for the 105°C rated power cord.
warninG:
□ Are not concealed or extended through a wall, floor, ceiling,
orther parts of the building structure.
□ Are not located above a suspended ceiling or dropped ceiling.
□ Are not permanently affixed to the building structure.
□ Are routed so that they are not subject to strain and are
protected from physical damage Are visible over their entire
length.
□ Are used within their rated ampacity as determined for the
maximum temperature of the installed environment specified
in the instructions.
warninG: Changes or modifications not expressly approved
by the party responsible for compliance could void the user's
authority to operate the equipment.
Tools/Hardware Required . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Package Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Care and Cleaning . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
notiCe: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on,
the user is encouraged to try to correct the interference by one or more of
the following measures:
□ Reorient or relocate the receiving antenna.
□ Increase the separation between the equipment and the receiver.
□ Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
□ Consult the dealer or an experienced radio/TV technician for help.
warninG: Risk of electrical shock. To reduce the possibility
of serious injury, always take the proper precautions and unplug
the fixture before moving or cleaning.
warninG:
□ These photobiological safety markings are based on testing of
the light output characteristic of a single horticultural luminaire.
□ Increased exposure risk to facility personnel may be present
depending upon the number of horticultural luminaires and their
placement and/or positioning within the plant growth facility.
warninG: It is the responsibility of the plant growth facility to
address these risks at the facility level and to ensure that people
entering the plant growth areas while the lights are on, are
aware of these risks and that appropriate safeguards are in place.
notiCe: Suitable for operation in ambient temperatures not exceeding
40°C/104°F. The temperature of the environment should be controlled via
a mechanical ventilation system, cooling system, or other means to ensure
the temperature within the growing space remains below 40°C/104°F when
the Grow Light is in operation.
2