Publicité
Les langues disponibles
Les langues disponibles
EN
FUNCTION TEST/OPERATION
Connect a consumer to the programmed
Cuveo receiver. For the permitted maximum
output of the consumer please see the
section on 'Technical data' for the relevant
Cuveo receiver.
Cover the light sensor on the radio twilight
switch. The programmed Cuveo receiver
should now be activated for the covered
period (or depending on the setting of
the sliding switches). The light sensor will
switch the programmed receivers off again
as soon as it senses light again.
CHANGING THE BATTERY
Carefully slide the radio twilight switch
upwards from the mounting point (screw).
Open the radio twilight switch by lifting the
back of the casing. Remove the existing
batteries and insert two new batteries of
type AAA into the battery compartment in
the right direction (note the plus/+ and
14
minus/- symbols). After exchanging the
batteries place the back of the casing on
the radio twilight switch again. Then slide
the radio twilight switch back onto the
mounting (screw).
MAINTENANCE AND
CLEANING
Servicing or repair works can only be
performed by a qualified person or at
a special service centre. There are no
components in the product that need to
be serviced.
•
The external surface can be cleaned by
using a dry, soft and clean cloth. Do not
press too hard on the front panel or on the
casing, as this can leave scratch marks on
the surface.
•
Dust can be easily removed by using a
soft and clean brush with long hairs and
bristles and a vacuum cleaner. In no event
Publicité
