Publicité
Les langues disponibles
Les langues disponibles
EN
MOUNTING THE RADIO
TWILIGHT SWITCH
The radio twilight switch is suitable for
operation both outdoors and indoors. The
radio twilight switch should not be hung in
the immediate vicinity of a lamp as the light
can cause incorrect switching. When drilling
holes in the wall or mounting the twilight
switch on the same please ensure that no
cables or wires are damaged. In order to
ensure optimum recognition, the twilight
switch must be placed in such a way that
it can easily recognise light and dark. Pay
attention to this when mounting the radio
twilight switch.
a.) The radio twilight switch is mounted on
the wall with a screw. (Use suitable screws
and dowels if necessary, depending on
the surface.)
b.) Then slide the radio twilight switch onto
the screw from above. Done.
12
INITIAL OPERATION
Programming the radio twilight
switch to a Cuveo receiver
a.) Open the radio twilight switch by lifting
the cover.
b.) If the battery compartment is at the bottom
you will find two sliding switches above for
setting the duration of the activity of the
programmed Cuveo receiver. The time can
be set at 2, 4, 6, 8 seconds, minutes or
hours or automatic operation.
c.) Now insert two batteries of the type AAA into
the battery compartment in the right direction
(note the plus/+ and minus/- symbols).
d.) Now switch a Cuveo receiver to learn mode
(see the operating instructions for there levant
Cuveo receiver). This is signalled by a flashing
LED on the receiver.
Publicité
