Publicité
Les langues disponibles
Les langues disponibles
e.) Before the LED on the receiver stops flashing,
press the 'Learning' button on the radio
twilight switch to which the Cuveo receiver
is to be programmed. The red LED on the
receiver will light constantly. The programming
process has been successfully completed.
f.) For more receivers please repeat the
steps c - e.
g.) After the successful programming process
you need to place the back of the casing
on the radio twilight switch again.
h.) Then slide the radio twilight switch back
onto the previously fitted mounting
(screw) from above.
Teaching the switching
threshold
When the desired level of brightness for
activation of the twilight switch has been
reached at the location of use, please
proceed as follows to set the
switching threshold:
a) Press and hold the 'Learning' button until
the LED next to it flashes.
b) After the LED has flashed slowly 5 times,
it flashes rapidly 8 times. During this time
the switching threshold (brightness of the
environment) is learned. Therefore you
should remove your hand from the device
during this time to avoid affecting the
brightness at the sensor.
Deleting the radio twilight
switch on a Cuveo receiver
Please adhere to the notes in the
operating instructions for the Cuveo
receiver in this regard.
EN
13
Publicité
