Bimar KFC-817 Notice D'instructions page 15

 "
is filled with: this function is most effective in drier air, and is less
effective as relative humidity increases (RH). The button starts and stops
the water pump. If the water level is below the minimum, the floater
stops the pump
"0" button stops both the ventilation function and the appliance. It is

started by pressing it.
 " " button starts ventilation at minimum speed.
" " button starts ventilation at medium speed.

" " button starts ventilation at maximum speed.

" " button, see above.

USE
To start the appliance, plug it into the mains and choose the required functions.
To turn the unit off completely, after pressing the " 0 " button, remove the plug
from the plug point.
If the appliance is not being used for long periods of time, remove the plug from
the plug point and empty the water tank.
CLEANING AND MAINTENANCE
Important: before performing routine cleaning, remove the plug from the mains.
 Regularly check that the filters are clean and that the water in the tank does
not contain deposits or substances to ensure that the functions are as effective
as possible.
 To clean the filters, loosen the two screws on top, remove the frame and clean
the dirt with a vacuum cleaner or a brush, making sure that the surfaces are
not damaged, and rinse with running water. Allow to drip dry completely, place
it back in position and tighten the screws.
 To clean the tank use a soft cloth to remove any deposits on the surface,
taking care not to damage the pump and other parts.
 To clean the body, use a soft cloth dampened with water and, if necessary, use
also a mild everyday detergent.
 Do not use abrasive or corrosive products.
 Do not immerse any electrical parts in water or another liquid. In the event this
occurs, dry carefully and check that the electric parts are perfectly dry and,
" button: cools the air and evaporates micro-particles of H²O it
15/44