Image Editing - DNT DigiMicro Profi II Mode D'emploi

Software
Menu bar
Timer
Capture:
Foto:
Video:

Image editing

Select photo or video mode.
Start time setting.
Set the interval time in seconds.
Setup the video length in seconds.
Setup the total number of photos or videos.
Number of already recorded photos or videos
Start/Stop of the timer.
Single image
Starts recording a video. Click again to stop recording.
Fullscreen mode
Focus microscope on the attached calibration ruler and then adjust the
magnification till the picture is clear. Take a picture for the selected area
when the dial is parallel to the crossing as below .
Double-click on the picture to enter into
measurement interface as below.
Click Calibration icon , and then move mouse
to the picture. Click on the beginning and
ending points across a known value. Now a
dialog will popup as below and you need to
enter the exact value of the measurement
sample into 'Actual dimension'.
Then the software will automatically calibrate
the magnification rate. Click 'OK' and the adju-
sted magnification rate will show in the upper
right corner.
- 28 -