TaoTronics SOUNDLIBERTY 53 Mode D'emploi page 8

Note:
If you want to change to couple mode, simply take out the other earbud from
the charging case, they will pair with each other automatically.
Restore to Factory Settings
If you failed to pair your device with the earbuds, please restore them to
factory settings as instructed below:
1. Take the earbuds out of the charging case, then place them back again.
Tap and hold the Multifunction Touch Control of both earbuds for 10
seconds until the LED indicators flash three times to enter reset mode.
2. If you have paired your device with the earbuds before, remove
"TAOTRONICS SoundLiberty 53" from the bluetooth device list and pair
again.
3. Take out both earbuds, and they will pair with each other automatically. Pair
them with your device when the LED indicator on the right earbud flashes
blue and that on the left earbud flashes blue and white alternately.
Note:
If you want to pair the earbuds with another device when you have already
paired them with a device, deactivate the Bluetooth function on the paired
device or clear "TAOTRONICS SoundLiberty 53" from its Bluetooth list.
Restore the earbuds to factory settings as instructed above if pairing failed.
07
OPERATION AND FUNCTIONS
Function Operation
Tap the Touch Control on
Play / Pause
either of the earbuds twice
Tap the Touch Control on the
Volume +
right earbud
Tap the Touch Control on the
Volume -
left earbud
Tap the Touch Control on the
Next Track
right earbud three times
Tap the Touch Control on the
Previous Track
left earbud three times
Answer Phone Tap the Touch Control on
Call either of the earbuds once
Hang up Tap the Touch Control on
Phone Call either of the earbuds twice
Tap and hold the Touch
Decline an
Control on either of the
Incoming Call
earbuds for 2 seconds
When paired successfully,
press and hold the Touch
Turn On / Off
Control on either of the
Voice Control
earbuds for 2 seconds until a
beep is heard.
Voice Prompt
/
Toots when highest setting
is reached
Toots when lowest setting
is reached
/
/
Ring tone sounds when call
is incoming
Toot when Connected
Toot
Toot
Toot
08