TaoTronics SOUNDLIBERTY 53 Mode D'emploi page 9

Clear Pairing Refer to the "Restore to
List Factory Settings" section
Go into Pairing
Refer to the "Pairing" section
Mode
Successfully
/
Paired
Bluetooth
out of
/
Range /
Disconnected
Note: Only when you are wearing the earbuds can you hear the voice prompt.
CLEANING AND MAINTENANCE
1. Clean the earbuds and the charging case on a regular basis.
2. Use dry and soft cotton cloth to wipe the unit.
Note: Do not insert anything into the product.
3. Keep away from sharp objects to avoid scratches.
4. Put the unit in a dry and shady place if it is to be idle for a long time.
5. Do not clean the product with detergent or chemicals.
09
Toot
Pairing
Connected
Disconnected
TROUBLESHOOTING
No. Problem Solution
Failed to turn on the
Earbuds low battery, please charge them
1
earbuds
• Place the earbuds into the charging
Failed to charge the
case properly
earbuds
2
• Make sure the charging case is charged fully
Can't charge the Make sure the charging cable is intact
3
charging case and plugged in properly
The earbuds reconnected with previously
paired device automatically:
• Deactivate the Bluetooth function of
Can't find
"TAOTRONICS
4
SoundLiberty 53" in the
Bluetooth device list
• Put the device to be connected and the
• Turn on the device and activate its
Failed to pair the
5
earbuds with your
• Bring the earbuds into pairing mode
device
No sound in one of the
6
earbuds in couple
earbuds mode
previously paired device or clear
"TAOTRONICS SoundLiberty 53" from
its Bluetooth device list, and then
search again
earbuds within 10 meters / 33 feet
Bluetooth function before pairing
as instructed in the "Pairing" section
Place both earbuds back to the charging
case then take them out, they will pair
with each other automatically. If pairing
failed, restore them back to the factory
settings as instructed in the "Restore to
Factory Settings" section
10