Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
50-255
50-91
92-133
134-17
CH14
176-21
218-25
1. If you using a controller with 5 pins DMX output, you need to use a 5 to 3 pin
adapter-cable.
2. At last unit, the DMX cable has to be terminated with a terminator. Solder a 120 ohm
1/4W resistor between pin 2(DMX-) and pin 3(DMX+) into a 3-pin XLR-plug and plug
it in the DMX-output of the last unit.
3. Connect the unit together in a 'daisy chain' by XLR plug from the output of the unit
to the input of the next unit. The cable can not be branched or split to a 'Y' cable.
DMX512 is a very high-speed signal. Inadequate or damaged cables, solder joints or
corroded connectors can easily distort the signal and shut down the system.
4. Each lighting unit needs to have an address set to receive the data sent by the
controller. The address number is between 0-511 (usually 0 & 1 are equal to 1).
by CH2 and CH3)
Total control choice graphic pattern (strobe
is affected by CH3)
0-49
(CH4, CH13) effective
RED
GREEN
BLUE
5
WHITE
7
ALL BRIGHT
5
(CH4, CH13) is invalid
invalid
13
Publicité
Table des Matières
