Honeywell HUL570 Serie Manuel D'instructions page 4

FILLING/REFILLING THE WATER TANK
Option 1: To Fill Tank at the Humidifier
Step 2
Step 1
1. Pour cool water from a pitcher or jug directly into Water Tank.
2. Fill to the MAX line marked on the outside of the Tank or to the MAX indicator on the
Tank Cover. Replace the Tank Cover if it was removed for filling.
Option 2: To Fill Tank at the Sink
Step 2
Step 1
1. Grasp Tank Handle and lift Water Tank to remove from Base. Carry Tank to sink.
2. Fill Tank with cool water to the MAX line marked on the outside of the Tank or to the
MAX indicator on the Tank Cover. Replace the Tank Cover if it was removed.
3. Carry Water Tank back to humidifier.
Note: The Tank should be carried using two hands; one hand on the Handle located
on top of the Tank and other hand supporting the bottom of the Tank.
4. Replace the full Tank on the Base.
CAUTION: Use care when handling Water Tank to avoid unnecessary impact.
Banging or dropping the Water Tank could result in damage to the Tank that may
cause leaking.
6
(CONTINUED)
Step 3 Step 4
$
USING YOUR HUMIDIFIER
How to Use
Step 1 Step 2
1. Power: With the Power Knob in the OFF position ( O ), plug humidifier into a polarized
120V outlet.
CAUTION: TO AVOID ELECTRIC SHOCK DO NOT PLUG HUMIDIFIER INTO OUTLET
WITH WET HANDS.
2. Output: Turn the Power Knob clockwise to highest setting.
3. Position humidifier to direct mist output away from walls, furniture and bedding.
Mist Outlet can rotate 180° and is removable for cleaning.
4. Humidity Level: When a comfortable humidity level is reached, turn Power Knob to a
lower setting. A comfortable humidity level is between 40-60%.
CONDENSATION: If you notice condensation on the walls, windows or around unit,
your humidity level is too high. Turn humidifier off and open door to room.
To monitor your humidity level, use a humidity monitor such as the Honeywell HHM10B,
HHM10 or H10C available at retailers or www.HoneywellPluggedIn.com.
Note: Auto shut off feature will activate when water runs out of the Tank or the Tank is removed
from the unit. The auto shut off will not turn off the Power Knob light; it will just turn off the fan
and nebulizer.
Daily Maintenance
Step 2
Step 1
1. Turn off, unplug and remove Tank Cover. Empty Water Tank.
2. Empty Reservoir by slowly pouring from the top of the Housing on the opposite side from the
Mist Outlet and away from Power Knob. Wipe outside of housing to dry any water that
may have escaped between Base and Housing.
3. Rinse Tank, wipe clean and dry with a soft cloth or paper towel.
4. Refill Water Tank with cool water according to Filling/Refilling the Water Tank instructions.
Note: Ensure the Float Paddle remains properly installed before filling. See Float Paddle
Installation instructions if necessary.
CAUTION: Improper placement of the Float Paddle could result in leaking or water
not feeding to the Reservoir.
Step 3 Step 4
Step 3 Step 4
7