Installation - Zen & Pur OSMOSEUR ORIGINE Manuel D'utilisation

Introduction
Install the water purifier on a solid, ventilated and stable worktop, away from any heat source. In order to ensure
the quality of water intended for consumption, use filters marketed by the manufacturer.
Filling
Remove the lid from the tank (7) (see diagram 3).
Lift the water intake tank to remove it. .
Empty the tank of its residual water (about 1l after filtering).
Fill the tank with fresh water and put it back in place on its base (see diagram 4).
Put the tank lid back in place (see diagram 1).
W A R N I N G
The device will not work properly If the tank lid is not properly put back in place!
to fill the tank admission with another liquid. Only tap water can be used.
Connecting to the sector
Connect the power outlet to the sector (see diagram 1).The device beeps, then the display interface and usage
control turn on, indicating that the device is now ready for use.
W A R N I N G
This device is designed to work only with a power supply in 220-240 V AC and should ideally
have its own wall socket with a rated power 10 A and grounding.
5
I N S T A L L A T I O N
It is forbidden
33