Qlima A 68 Manuel D'utilisation page 53

Masquer les pouces Voir aussi pour A 68:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 30
CLEANING THE CLEANABLE HEPA-TYPE FILTER
1.
Release the inlet grill by pressing on the locking latch (see diagram of Main Parts).
2.
Remove the inlet grill from the unit as shown below.
3.
Grasp the left and right frames of the cleanable HEPA-type Filter through the indentations on the sides of the
filter enclosure and remove the filter.
4.
To clean the cleanable HEPA-type Filter, use the brush or crevice attachment with a vacuum cleaner. Run the
attachment along the inlet and outlet side of the filter, cleaning between the crevices as much as possible. Do
not use water or any household cleaners or detergents to clean the cleanable HEPA-type Filter.
5.
Once the cleanable HEPA-type Filter has been cleaned and checked for any possible damage, replace the filter
back in the reverse direction described here. Plug in the unit and hold down the ION + UV/VOC button for 3
seconds. The clean filter light will go off and your cleaning maintenance is done.
CLEANING EXTERNAL SURFACES
1.
Turn off and unplug unit.
2.
Use a washcloth slightly dampened with a little water and dishwashing soap to wipe the outer
case surfaces.
3.
Do not allow water to slip into the internal parts as this could damage your unit and result in elec-
trical shock and injury to you.
4.
Allow the unit to thoroughly dry before use.
UV LAMP
The lifetime of the UV lamp is up to 12 months of continuous, effective operation. After this time, the
bulb may remain illuminated, but its effectiveness is greatly reduced. For maximum effectiveness,
please replace the UV bulb annually.
If the lamp stops functioning or needs replacement, please contact the retailer to order a replacement
lamp.
4
4
53
53

Publicité

Table des Matières
loading

Table des Matières