Beem Robustica Mode D'emploi page 34

31
5. To rinse the device, allow two tankfuls (14 cups) of clear water to run through it. The
device is now descaled and ready to be used again.
The message REINIGEN (CLEAN) regularly appears on the display (10) as a
reminder that the device needs to be cleaned or descaled. The symbol disappears
again after two run throughs.
Storage
Disconnect the device from the mains power when it is not going to be used for a
prolonged period. Clean the device again if necessary (see the "Cleaning and Care"
chapter) and let it dry completely.
Store the device and all accessories in a dry, clean, frost-free place that is protected from
direct sunlight and cannot be accessed by children or animals.
Troubleshooting
If the device does not work properly, check whether you are able to rectify the problem
yourself. If the problem cannot be solved with the steps that are listed, contact the
customer service department.
Do not attempt to repair a defective electrical device yourself!
Problem
Nothing is shown
on the display (10).
The fuse in the fuse
box is triggered.
Water runs out of
the device.
03840_DE-EN-FR-NL_A5_V2.indb 31 03840_DE-EN-FR-NL_A5_V2.indb 31
Possible cause
Is the mains plug inserted in
the plug socket correctly?
Is the plug socket defective?
No mains voltage is present.
Is the display defective?
Too many devices
connected to the same
circuit.
No error can be identifi ed.
Is there too much water in
the water tank (7)?
Fix
Insert the mains plug.
Try another plug
socket.
Check the fuse of the mains
connection.
Contact our customer
service department.
Reduce the number of
devices in the circuit.
Contact our customer
service department.
Do not overfi ll the water
tank!
27.09.2017 08:25:11 27.09.2017 08:25:11
EN