HumanTechnik Signolux Set Mode D'emploi page 16

10. Setting the melody
You can adapt the melody for each icon:
a) First trigger a signal (e.g. operate door-
bell pushbutton).
b) The icon assigned to the transmitter
should illuminate and the previously
chosen melody should be heard.
c) Press and hold the melody setting but-
ton »♫« (fig. 6) for two seconds.
Let go of the button and press it repeat-
edly until you have found the desired
melody (you can choose from 16 melodies).
d) Once the icon ceases to flash, the
selected melody has been assigned.
11. Deleting transmitters from
receiver memory
Do the following if you want to delete a trans-
mitter from the memory:
a) Keep the key »●« (fig. 6) pressed for
some time. The icons light up in se-
quence. Let go of the key as soon as you
see the desired icon.
b) Now press key »●« and the melody set-
ting button »♫« (fig. 6) at the same time.
All icons light up briefly to confirm that
the transmitter has been deleted from
the receiver.
Please note that this will remove all assigned
transmitters from the selected icon.
16 English
12. Battery level indication
The receiver informs about the state of the
batteries of the receiver as well as the batte-
ries of the transmitters:
- A sufficient battery level of the receiver
is indicated by the red control lamp
flashing every 5 to 6 seconds.
- A low battery level of the receiver is in-
dicated by the red control lamp flashing in
short sequence (once per second).
Please replace the receiver batteries as
soon as possible.
- A low battery level of a transmitter is indicated
by the red control lamp shining together with
the symbol of the according transmitter when
it's signal is triggered.
Please replace the batteries of the accor-
ding transmitter as soon as possible.