HumanTechnik Signolux Set Mode D'emploi page 13

b) Using a pointed object (e.g. biro) care-
fully press now the small pin on the left
side (fig. 1 A).
c) Now you should be able to push up
and remove the transparent plastic face
(fig. 1 A).
d) You can now open the small screw (fig. 1 B)
using a small Phillips screwdriver and re-
move the front of the doorbell pushbut-
ton behind which there is the PCB with
the battery.
e) Insert the battery (coin cell CR 2032) into
the plastic support on the PCB (fig. 2 D).
D
E
Figure 2: Battery compartment doorbell
pushbutton
f) If you would like to replace a battery, re-
move the old one with a small flat screw-
driver from its plastic support by lifting
the edge slightly (fig. 2 E). Afterwards
you can insert a new battery. Kindly
ensure correct polarity of the battery.
g) Please refer to step 3 for the assembly of
the doorbell pushbutton.
2. Label name tag and insert
a) If you have not opened the housing yet,
kindly proceed as described under step
1 a) to c).
b) The transparent plastic face consists of
two parts. The labelled name tag can
be inserted between them (dimensions:
94 x 24 mm). Kindly ensure that the la-
belling is right way up. Kindly also keep
in mind that the name tag has a cutout
that does not cover the light diode or at
least lets the light pass through.
c) Put the two transparent parts of the plas-
tic face back together so that the notch-
es interlock.
d) Please refer to step 3 for the assembly of
the doorbell pushbutton.
3. Assembly of the doorbell pushbutton
a) If you have changed only the name tag
proceed to step e)
b) Before assembling ensure that the small
screw (fig. 1 B) can grip at the right spot.
If required turn one part of the housing
by 180°. Please make sure that the rub-
ber gasket sits correctly within the hous-
ing.
c) Insert the front face into the housing of
the doorbell pushbutton and press both
firmly together until the housing parts
lock in place.
d) Carefully drive in the small screw (fig. 1 B)
with a small Phillips screwdriver.
e) Now hold the doorbell pushbutton in
such a way that the small screw (fig. 1 B)
is on the right.
f) At the right side of the pushbutton there
is a small opening (fig. 1 C) where the
hinge pin of the transparent plastic face
can be inserted.
g) You can now position the transparent
plastic face in such a way until it has
almost reached its final position. You
only have to carefully press the small
pin (fig. 1 A) and to lock the transparent
plastic face in place.
English 13